So the advantage of using Dot 3 is that with a vented system like Honda uses it will last a little longer before it has pulled too much moisture out of the air and needs to be changed. Indeed, DOT 3 / DOT 4 and DOT 5.1 brake fluids have the property to absorb humidity. Dot 4 pulls moisture out of the air about 20 % faster than Dot 3 Motul Brake Fluid Dot 3 & 4 102718 for Honda X 11 in Brakes Fluid. 1,131 300+ bought in past month 1140 (0.95/Fl Oz) FREE delivery Tue, Jul 11 Only 2 left in stock - order soon. While Dot 3 will absorb moisture right out of the air, because Dot 4 and Dot 5.1 does that worse, they will become contaminated with water faster and used up in a shorter amount of time in a system that is vented to the atmosphere like a Honda. Genuine Honda Fluid 08798-9008 DOT 3 Brake Fluid - 12 oz. When adding fluid to your Civic, it is important to check your owners manual for the correct type to add - it likely be either DOT 3, DOT 4 or DOT 5, also known. It is not enough that all these parts are working perfectly. But do not even think of using Dot 5 in a Dot 3 system. Master cylinder, Brake pedal, Mechanical linkage, Hydraulic line, Brake caliper, and Drum cylinder. Dot 5 is silicon based and does not mix well with Dot 3, or Dot 4, or Dot 5.1 So in a pinch you could use Dot 4 or Dot 5.1 in a Dot 3 system. Apparently a Heavy Duty version exists as well, which my 2012 Civic manual calls for. Although it is interchangeable with other brake fluids with a higher boiling point, if your vehicle is used for things such as getting to and from work, leisurely driving, getting from point A to B, then. SECTION 1: IDENTIFICATION 1.1 Product identifier Product : Honda Brake Fluid DOT 3Synonyms : NoneProduct Part Number:08798-9008, 08798-9008C, 08798-9108 1. The Honda Manual and web site says that only genuine Honda DOT 3 brake fluid can be used otherwise there could be issues such as rust. It boils at a lower temperature than Dot 4, and dot 5.1 even boils at a higher temperature than Dot 4. 1 Is there any difference between these I recently went to the Honda dealership to pick up some brake fluid and all they had was Genuine Honda Brake Fluid DOT 3. DOT 3 Brake Fluid: DOT 3 is the most common type of brake fluid you will find in a typical vehicle that is used for conventional purposes. So the Honda recommendation of flushing the brake fluid every 3 years is because you do not want too much water in your brake fluid because it will cause rust problems with the brake system.ĭot 3 is the low end of the quality spectrum with regard to brake fluid. Honda master cylinder revivors are vented to atmosphere, ( many other makes are not ), and brake fluid is hydroscopic ( attracts water sooooooo well that it actually pulls it right out of the air and it ends up in the brake fluid ).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |